A Heartfelt Testimonial from Mina Product Development Co. Inc.
At CH America, we are deeply grateful for the kind words and support from Mina Product Development Co. Inc. Their longstanding expertise in plastic injection
Oil, Lubrication & Preheat Functions
Oil & Lubrication Screen
1Oil & Lubrication
From the Machine Overview screen press F6 – 3 times to access the Oil, Lubrication screen.
2Oil Temperature
The recommended settings for the hydraulic oil temperature are:
Max Oil temp.: 60C
Cooling On temp.: 45C
Cooling Off temp.: 40C
Preheat temp.: 40C
3Lubrication
The recommended settings for lubrication can be found in the machine maintenance manual or on the sticker next to the lubrication pump (see photo below).
Lubrication Auto Cycle Intervals setting should NOT be set less than 100 or greater than 2000. Lubrication Time (After Feedback OK) should be 10 seconds or greater. Failure to follow these guidelines can cause excessive wear and tear on machine toggles.
Manual Lubrication,
Hydraulic Oil & Preheat Functions
1Press The CTRL Button
From the Machine Overview screen, press the CTRL button.
2Manual lubrication
Press F3. Press F3 again to stop. Otherwise the function will continue until the timer counts down to zero.
3Preheat Hydraulic Oil
Motor MUST be OFF, press F4. Press F4 again to stop. Otherwise the function will stop automatically when the oil is warm.
