Save on a New Injection Molding Machine with the SECTION 179 Tax Deduction !

2020 Deduction Limit = $1,040,000

2020 Spending Cap on Equipment Purchases = $2,590,000

Bonus Depreciation: 100% for 2020

Machines Currently in Our Warehouse

Stock

ModelUS Tons AvailabilityLocationMore DetailsPDF
Focus 60-SVP/266IN STOCKTORRINGTON, CTMore on This SeriesDownload PDF
Focus 60-SVP/266IN STOCKTORRINGTON, CTMore on This SeriesDownload PDF
JM88-MK697IN STOCKTORRINGTON, CTMore on This SeriesDownload PDF
JM88-MK697IN STOCKFACTORYMore on This SeriesDownload PDF
JM88-MK697NEW BUILDFACTORYMore on This SeriesDownload PDF
JM128-MK6141IN STOCKTORRINGTON, CTMore on This SeriesDownload PDF
JM128-MK6141IN STOCKFACTORYMore on This SeriesDownload PDF
JM128-MK6141IN STOCKFACTORYMore on This SeriesDownload PDF
JM168-MK6185IN STOCKTORRINGTON, CTMore on This SeriesDownload PDF
JM208-MK6229IN STOCKTORRINGTON, CTMore on This SeriesDownload PDF
JM208-MK6229NEW BUILDFACTORYMore on This SeriesDownload PDF
JM208-MK6229NEW BUILDFACTORYMore on This SeriesDownload PDF
JM258-MK6284IN STOCKFACTORYMore on This SeriesDownload PDF
JM258-MK6284NEW BUILDFACTORYMore on This SeriesDownload PDF
JM398-MK6438NEW BUILDFACTORYMore on This SeriesDownload PDF
JM468-MK6515NEW BUILDFACTORYMore on This SeriesDownload PDF
JM568-MK6626IN STOCKFACTORYMore on This SeriesDownload PDF
JM668-MK6736NEW BUILDFACTORYMore on This SeriesDownload PDF

Last updated October 12, 2021
Stock levels are subject to change without notice.

What is Section 179?

Section 179 is a Tax Code deduction which allows businesses to deduct the full purchase of qualifying equipment and/or software purchased or financed during the current tax year.


How does Section 179 work?

Rather than writing off qualifying equipment purchase(s) a little at a time, the Section 179 tax code allows businesses to write the entire purchase of up to $1,000,000 off the same/current tax year it is purchased. This tax code is aimed to assist businesses to get the equipment they need and now than wait. Since it’s a use-it-or-lose-it basis, there is no better time to invest in a new Ch-America Injection molding Machine.

Using the Section 179 Calculator, we drew up an example to reflect the potential savings of purchasing a MK6 Injection Molding Machine.

Example
Total Qualifying System Purchase $200,000
Section 179 Deduction (assuming 35% Tax) $200,000
Total First Year Deduction $200,000
Cash Savings on Purchase $70,000
Lowered Cost of Equipment (after Tax Saving) $170,000
Service

Services We Provide:

  • Technical support/troubleshooting over the phone
  • Scheduling for field service
  • Machine start-up
  • Preventive maintenance
  • Calibration / Settings tune-up
  • Customized service contracts
  • Machine repair
  • Retrofits
Get in Touch
Take advantage of these savings by investing in a new Injection Molding machine today!